This receiver is what you need, if you want to increase the life and accuracy of your firearm.

The replacement receiver is accurately CNC machined, from a 17-4 stainless casting. This will give you, more strength and closer tolerances, and a receiver that you will probably never wear out.

The receiver has a second hold down screw on the rear, which allows the receiver to be securely fastened down in the stock and bed, if you choose to.

The barrel port is threaded (3/4-16) which allows the barrel to be serewed in. With the receiver securely fastened in the stock, the barrel can then be free floated; whether you thread your existing barrel or add a new barrel, the accuracy is greatly improved.

With the help of a fixture (which can be bought from M.O.A. Corp), the replacement receiver can be installed working at your kitchen table, with little gunsmithing skill required. (Fixture Instructions)

With this replacement receiver and a good replacement barrel (I recommend Douglas Barrels, which you can buy already threaded and set up with the extractor groove cut), this set up and using the rest of your stock parts, you should be able to shoot less than 1/4" groups at 50 yards. Of course, you have to do your part. To shoot well, you must use good ammo.

When the conversion is completed, you will have spent money to improve your rifle; but the cost will be less than most of the more expensive custom guns, and will shoot just as well or better and you did it yourself.

Other features of the M.O.A. Replacement Receiver for your 10-22

•    The hole for the barrel is reamed at .6875 to accept the standard (but not recommended) slip in barrel.


•    The receiver is drilled and tapped to accept 10-22 scope mounts.


•    A cleaning rod hole will be drilled in the rear of the receiver for bore cleaning.